https://vulnerability.circl.lu Contains only the most 10 recent entries. http://www.rssboard.org/rss-specification python-feedgen en Tue, 29 Sep 2026 23:44:16 +0000 https://vulnerability.circl.lu/vuln/cve-2026-89945 <p><strong>Affected:</strong> Linux</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>ASoC: cs35l34: drain threaded IRQ before runtime suspend</p> <p>cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access.</p> <p>A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes.</p> <p>Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only logs request_threaded_irq() failures and keeps going, track whether the IRQ was actually installed before disabling or re-enabling it.</p> <p><strong>Affected:</strong> Linux</p> <p>In the Linux kernel, the following vulnerability has been resolved:</p> <p>ASoC: cs35l34: drain threaded IRQ before runtime suspend</p> <p>cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access.</p> <p>A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes.</p> <p>Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only logs request_threaded_irq() failures and keeps going, track whether the IRQ was actually installed before disabling or re-enabling it.</p> https://vulnerability.circl.lu/vuln/cve-2026-89945