CVE-2025-37945 — net: phy: allow MDIO bus PM ops to start/stop state machine for phylink-controlled PHY

Affected: Linux, Siemens SIMATIC S7-1500 CPU 1518-4 PN/DP MFP, Siemens SIMATIC S7-1500 CPU 1518F-4 PN/DP MFP, Siemens SIPLUS S7-1500 CPU 1518-4 PN/DP MFP

In the Linux kernel, the following vulnerability has been resolved:

net: phy: allow MDIO bus PM ops to start/stop state machine for phylink-controlled PHY

DSA has 2 kinds of drivers:

1. Those who call dsa_switch_suspend() and dsa_switch_resume() from their device PM ops: qca8k-8xxx, bcm_sf2, microchip ksz 2. Those who don't: all others. The above methods should be optional.

For type 1, dsa_switch_suspend() calls dsa_user_suspend() -> phylink_stop(), and dsa_switch_resume() calls dsa_user_resume() -> phylink_start(). These seem good candidates for setting mac_managed_pm = true because that is essentially its definition [1], but that does not seem to be the biggest problem for now, and is not what this change focuses on.

Talking strictly about the 2nd category of DSA drivers here (which do not have MAC managed PM, meaning that for their attached PHYs, mdio_bus_phy_suspend() and mdio_bus_phy_resume() should run in full), I have noticed that the following warning from mdio_bus_phy_resume() is triggered:

WARN_ON(phydev->state != PHY_HALTED && phydev->state != PHY_READY && phydev->state != PHY_UP);

because the PHY state machine is running.

It's running as a result of a previous dsa_user_open() -> ... -> phylink_start() -> phy_start() having been initiated by the user.

The previous mdio_bus_phy_suspend() was supposed to have called phy_stop_machine(), but it didn't. So this is why the PHY is in state PHY_NOLINK by the time mdio_bus_phy_resume() runs.

mdio_bus_phy_su…

Most recent entries from all

CVE-2025-37945 — net: phy: allow MDIO bus PM ops to start/stop state machine for phylink-controlled PHY